S60 L5-2.4L VIN 64 B5244S6 (2003)
Front Steering Knuckle: Removal and Replacement
Wheel Spindle, Replacing
Special tools:
999 5259
999 5045
951 2050
Removing the wheel spindle
Raise the car.
Remove
-
the wheel
-
the anti-roll bar link from the spring strut. Use a Torx wrench as a counterhold so that the boot is not damaged
-
the ABS sensor. Hang up the sensor using a piece of wire
-
The ABS sensor cable from the spring strut.
-
the brake caliper and limiter mounting screws
-
the limiter. Hang the caliper up using a piece of wire.
-
the drive shaft screw. Use a screwdriver as a counterhold on the brake disc
-
the locating pin holding the brake disc
-
the brake disc.
Slacken off the end of the drive shaft in the hub by knocking the drive shaft into the hub approximately 10-15 mm. Use a rubber or copper mallet.