S60 L5-2.4L VIN 64 B5244S6 (2003)
Install
-
Adjust the position of the wheel spindle and spring strut according to Wheel knuckle / spring strut, calibrating See: Front Steering Knuckle/Service
and Repair/Procedures. Tighten the wheel spindle to the spring strut with 105 Nm and angle-tighten with 90°. Use bevel protractor 951 2050
BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor.
-
the anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm. Counterhold with a Torx wrench so that the boot is not damaged.
-
The ABS sensor cable.
-
ABS sensor onto the wheel spindle. Tighten the ABS sensor. Tighten to 10 Nm.
Note! Make sure that the sensor seat in the wheel spindle is absolutely clean. Clean the ABS-sensor with a soft brush.
