S60 L5-2.4L VIN 64 B5244S6 (2003)
Lifting the sub-frame
Lift the sub-frame up completely.
At the same time locate the mounting screws for the steering gear on the sub-frame and, on right-hand drivecars, the screw for the collision protection
system.
Install the sub-frame brackets loosely together with the washers.
Install the four screws for the sub-frame. Use new screws. Do not tighten yet.
First tighten the screws on the left side of the sub-frame. Tighten to 105 Nm. Angle tighten 120°. Then tighten the right-hand side to the same values as
the left side.
Finally tighten the screws for the brackets on both sides. Tighten to 50 Nm.
Install the engine block heater (if applicable) on the left front mounting for the sub-frame.
Caution! Tighten the left-hand side first. The sub-frame guides are on the left-hand side.
Installing the nuts and screw for the steering gear
Install:
-
the four nuts and screws holding the steering gear. Use new nuts and new screws. Tighten to 50 Nm.
Applies to right-hand drive cars:
