S60 L5-2.4L VIN 64 B5244S6 (2003)
-
washer
-
the nut. Tighten to 70 Nm. Use socket 999 5467 and a 3/8" Torx-wrench as a counterhold.
Installing the spring strut
Install the spring strut in the bodywork using the new nuts. Tighten to 25 Nm.
-
Install the spring strut on the wheel spindle. Use new screws and new nuts
-
Adjust the spring strut and wheel spindle to the measured value.
Note: Ensure that measurement is performed at same points as when removing.
Tighten to 105 Nm. Angle-tighten 90°. Use bevel protractor 951 2050.
Install:
-
the anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm. Counterhold using a Torx wrench to prevent damage to the boot
-
the ABS sensor. Tighten to 10 Nm.
Note: Ensure that the ABS sensor seat in the wheel spindle is absolutely clean. Clean the ABS sensor with a soft brush.