S60 L5-2.4L VIN 64 B5244S6 (2003)
Install:
-
the cable harness on the sub-frame and the control arm for the shock absorbers
-
the connector on top of the sub-frame.
Press up the control arm using a mobile jack.
Fix the shock absorber in the lower mounting. Tighten the M12 screw.
Remove the mobile jack.
Install:
-
the nut for the upper mounting for the shock absorber. Tighten. See Tightening torque See: Specifications. Use socket999 5500 SOCKET UPPER
NUT REAR SHOCK ABSORBER See: Tools and Equipment/999 5500 Socket Upper Nut Rear Shock Absorber and a Torx-wrench as a
counterhold
-
soundproofing.
Fold back the front edge of the side panel in the cargo compartment. Install the clips.
Fold the rear seat backrest back into position.
Reinstall the carpet.
Install the wheel. See Installing wheels See: Wheels and Tires/Wheels/Service and Repair.
Finishing
Calibrate the position sensor Four-C
Note! Four-C and Bi-Xenon lamps have the same position sensor.
Check and adjust the headlamps in accordance with: Headlamps, aligning See: Lighting and Horns/Headlamp/Adjustments.
Spring Strut Rear, Replacing
Spring strut rear, replacing
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Removal
Preparatory work
