S60 L5-2.4L VIN 64 B5244S6 (2003)
Note! For tightening torques, see Tightening torque See: Specifications.
Installing the spring strut
Install:
-
the spring strut
-
the screw for the spring strut. Tighten the spring seat. See Tightening torque See: Specifications.
Installing the shock absorber connectors
Connect the connectors for the shock absorbers on the top of the sub-frame.
Installing the rear suspension
Carefully raise the rear suspension.
Warning! Check that the vehicle does not lift out of the car jack arms when working with the lifting table.
Note! Guide in the propeller shaft when lifting operation.
Note! Ensure that the brake pipes or cable harnesses are not trapped.
Install the screws for the front mountings on the sub-frame (install the screws through the brackets).
Tighten the front mountings using M12 screws.
Install:
-
the brake pipes in the plastic clips on the brackets
-
the M8 screw for the bracket for the fuel filter
-
the M8 screw for the brake line mounting stay.
Remove the lifting table.
Install:
-
the exhaust system. See Exhaust system, replacing See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair
-
the propeller shaft in the viscous coupling/Active on Demand Coupling. See Final drive, replacing, M58, M66 AWD, AW50/51 AWD .
