S60 L5-2.4L VIN 64 B5244S6 (2003)
Remove the gearbox cable from the lever on the gearbox
Unhook the mounting with the connectors for the gearbox from the bracket for the air cleaner (ACL) housing.
Remove the tie straps from the cable harness.
Remove the mounting from the cover for the control system.
Separate the connectors. Remove the connectors from the mounting.
Removing the lever on the gear shift linkage rod
Remove:
-
the lever on the gear shift linkage rod
-
the screw for the gear selector sensor and cable harness.
Twist out the tab on the cable harness holder.
Installing the lifting beam and lifting hook
Install lifting beam 999 5716 Reading off tool See: Tools and Equipment/999 5716 Reading Off Tool directly above the engine's lifting eye. Position the
lifting beam's brackets as illustrated.
Connect hook 999 5460 Lifting hook See: Tools and Equipment/999 5460 Lifting Hook to the lifting eye at the rear edge of the engine. Apply the hook
to take the load off the engine pads.
