S60 L5-2.4L VIN 64 B5244S6 (2003)
Reinstall the control system cover on the gearbox. Tighten the screws alternately. Tighten to 12 Nm. Torx TX 40.
Stretch the cable up to the oil temperature sensor.
Install:
-
the oil pipe on the gearbox with a new O-ring
-
the return line to the control system cover
-
the cable harness to the holder on the cover
-
the ground lead on the transmission
Installing the sub-frame
Position the mobile jack 998 5972 JACK See: Tools and Equipment/998 5972 Jack under the left side of the sub-frame.
Press the frame up against the car body. At the same time locate the ball joint on the control arm and the steering gear screws to the frame.
Note! Use new screws. Lube the screws with oil.
Install new screws (M14) in the sub-frame. Tighten screws with 105 Nm. Install the support plate's screws at the same time.
Right-hand side
Align the drive shaft in the hub.
Remove the protective cover from the ball joint. Locate the ball joint pinion in the control arm. Position the mobile jack under the right side of the
sub-frame. Press up the sub-frame and install the new screws in the same way as on the left-hand side. Remove the jack.
Finally tighten the four screws for the sub-frame to 120°.
Tighten the screws for the support plate. Tighten to 50 Nm.
Installing components in the steering gear and sub-frame
