S60 L5-2.4L VIN 64 B5244S6 (2003)
-
Connect the cable (2) for the antenna amplifier (1) to the connector (3) for the antenna in the bumper
-
Position the antenna amplifier on the edge of the panel in front of the right tail lamp as illustrated
-
Tighten the antenna amplifier to the edge of the panel
-
Connect the routed cable to the socket (4) on the antenna amplifier.
-
Clamp the cable along the cable duct in the cargo compartment. Use tie straps from the kit.
-
Reinstall the panels in the cargo compartment
-
Reinstall the sill trim panel in the right-hand rear door
-
Fold the seat cushion back into place
-
Fold the backrest back into place
-
Fold the right front floor carpet back into place.
Reinstall:
-
the sill trim panel in the right front door
-
the seat. Tighten the seat using the two new screws from the kit. Tighten to 40 Nm (29.5 ft.lb)
-
the two covers
-
the right side panel for the centre console.
Note! If there are two black electrical cables in the connector, remove the right-hand (looking from the back of the connector) electrical cable.
Secure the right-hand electrical cable. Install the new electrical cable.
-
Connect the antenna cable to the two-pin connector (1), disconnected from the radio, to the spare terminal. Pry up the connector at the rear edge.
Pull out the green plastic catch (2)
-
Insert the cable in the free terminal (3). Lock the cable in place using the catch.
-
Insert the radio in the radio tray. Connect the antenna cable and the connectors to the radio
-
Reinstall the bracket with the radio.
-
Connect the connectors to the dashboard environment panel. Reinstall the dashboard environment panel.
-
Reinstall the panel in front of the gear selector lever.
