S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Take the remote control keypad (from the kit) and insert it in its socket
-
Press the keypad until the catch engages
-
Install the screw. Tighten the keypad
-
Connect the connector to the keypad.
-
Reinstall the horn, according to (V70R50). Ensure that the three springs are correctly positioned. Check that the ground lead is not trapped
-
Tighten the screws crosswise. Tighten to 6.5 Nm (5 ft.lb)
-
Reinstall the ground lead. Tighten the ground lead
-
Connect the connector for the horn and the keypads
-
Check the function of the horn. Press the horn all the way round its circumference.
-
Check that the two springs (1) are in position
-
Press the two connectors for the sender cables for the airbag into the steering wheel module.
NOTE: The wiring must be routed through the existing holder (2).
-
Insert the two pins on the reverse of the steering wheel module in the two springs. Ensure that the sender cables are unimpeded
-
Press the steering wheel module into the mountings. Two clicks should be heard.
-
Turn the ignition key to position II
-
Reconnect the battery negative lead.