volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Adapter 7 to 4 Pole Wiring For Towing|Page 24477 > < Adapter 7 to 4 Pole Wiring For Towing|Page 24475
Page 3
background image

-

Turn the ignition key to position 0. Remove the ignition key from the ignition switch.

NOTE:  Wait at least five minutes before disassembling the connectors or removing other electrical equipment.

-

Connect the cable harness connector for the tow hitch according to point 1 in the Installation Instructions for the appropriate cable harness.

-

Fold up the floor hatch

-

Press in the centre of the clips until a "click" is heard. Remove the clips

-

Remove the plastic nut.

-

Repeat the operation on the right-hand side.

-

Turn the handle (1) on the right and left-hand sides a quarter turn

-

Fold the side panels inwards. Remove the panels

-

Pull the tailgate sill trim panel (2) forwards on the right and left hand sides until the two clips on each side release. Carefully pull the panel with
some force as it is tightly secured

-

Remove the wiring (3) for the cargo compartment lighting

-

Then pull the sill trim panel straight up until the four clips at the lower edge release. Remove the sill trim panel.

Remove:

-

the two nuts from the front edge of the battery holder and the screw from the rear edge

-

the battery holder

Adapter 7 to 4 Pole Wiring For Towing|Page 24477 > < Adapter 7 to 4 Pole Wiring For Towing|Page 24475