S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Twist the bracket up with the trailer connector so that it is straight and is positioned slightly away from the bumper
-
Align the cable harness in the cut out. Tighten the bracket
-
Adjust the cable harness all the way from the trailer connector and in the rubber grommet so that the cable harness does not hang under the car.
Press in the excess cable length through the rubber grommet
-
Tighten the two tie straps (1) that were positioned earlier.
-
Cut out a hole (1) where the cable harness protrudes from the inside of the bumper on the left-hand side of the tow hitch and enters the rubber
grommet in the floor
-
Remove the masking tape (2) from the bumper.
Finishing work
-
Tighten the screw (1) on both sides
-
Rivet (2) the bumper on the underneath on both sides as illustrated
-
Reinstall the bumper nuts. Tighten the nuts. Tighten to
18 Nm (14 ft.lb.)
-
Install the rubber seals to cover the four nut holes.
Reinstall:
-
the antenna connector
-
the mudguards, if applicable
-
the rear wheels. Lower the car.
