S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Seal the opening for the heated oxygen sensor (HO2S).
Remove the upper heat deflector plate over the manifold.
Right-hand drive only
Remove the lower heat deflector plate over the three-way catalytic converter (TWC).
Removing the exhaust manifold and three-way catalytic converter (TWC)
Remove (left-hand drive cars)
-
the nuts securing the manifold and the three-way catalytic converter (TWC) to the cylinder head
-
lift the manifold and three-way catalytic converter (TWC) off the studs at the cylinder head
-
the gaskets.
Remove (right-hand drive cars)
-
the nuts securing the manifold and the three-way catalytic converter (TWC) to the cylinder head
-
lift the manifold and three-way catalytic converter (TWC) off the studs at the cylinder head. Place to one side
-
the heat deflector plate over the steering gear
-
the upper collision guard at the steering gear.
Lift the manifold and three-way catalytic converter (TWC) out.
Remove the gaskets.
Note! Note the process for removal. This will make installation easier.
Installing the exhaust manifold and three-way catalytic converter (TWC)
Note! For tightening torques, see: Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque.
Note! To ensure that there is no exhaust leakage, see: Flanged joint, assembling See: Exhaust System/Exhaust Pipe/Service and Repair/Flanged
Joint, Assembling.
Clean the gasket faces. Check that the studs are tightened.
Install new gaskets.
Lubricate the studs. Use paste 116 1408.
Warning! Avoid skin contact with the paste.