S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Exhaust Manifold Gasket: Service and Repair
Exhaust manifold / gasket, replacing
Special tools:
999 5543 SOCKET NV-22 HO2S See: Tools and Equipment/999 5543 Socket NV-22 HO2S
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Preparation
Remove
-
the right front wheel
-
the splash guard under the engine
-
the right drive shaft. See Half shaft, right, replacing, B5254T2, M58, B5254T2, M56 See: Transmission and Drivetrain/Drive Axles, Bearings and
Joints/Axle Shaft Assembly/Service and Repair/Half Shaft, Right, Replacing.
Remove
-
the heat deflector plate above the coolant pipes and hoses for the oil cooler
-
the support bracket between the cylinder block and the manifold and three-way catalytic converter (TWC)
-
the nuts where the front exhaust pipe and three-way catalytic converter (TWC) join.
Remove the brake pipe from the holders at the front SIPS member.
Remove the screws holding the SIPS member to the bodywork.
Unhook the rubber mountings for the rear exhaust system from the holders.
Pull the exhaust system back so that it releases from the flange at the manifold and three-way catalytic converter (TWC). Put it to one side.
Remove
-
the engine stabilizer brace between the suspension turrets
-
the air preheating hose between the air cleaner (ACL) and the heat deflector plate.
Disconnect the connector for the front heated oxygen sensor (HO2S).
Remove the heated oxygen sensor (HO2S) wiring from the rear engine mounting.
Remove the front heated oxygen sensor (HO2S).