S60 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Remove the connector (1) from the terminal (2) above the cable duct under the rear seat cushion
-
Connect the connector (3) from the routed cable harness to the terminal (2)
-
Connect the connector (4) from the routed cable harness to the disconnected connector (1). Wrap foam tape (from the kit) around them
-
Hide the connectors under the insulation panel
-
Fold the insulation panel back into place.
Applies to S60 and S80
-
Install the new bracket on the right-hand rear side member as illustrated
-
Install and tighten the bracket parallel with the side member. Use the screw and the nut from the kit
-
Tighten to 10 Nm (8 lbf.ft.)
-
Drill a - 4 mm (5/32") hole in the side member, through the front hole in the bracket
-
Tighten the front mounting for the bracket to the side member. Use a self tapping screw from the kit
-
Remove any swarf. Rust-proof the hole edge.
Applies to the V70
-
Tighten the bracket for the accessory electronic module in the rear right-hand hole for the floor support parallel with the side member. See the
illustration