S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Variable Valve Timing Actuator: Testing and Inspection
Variable valve timing unit, checking and adjusting
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Special tools:
999 5451 ADJUSTMENT TOOL See: Tools and Equipment/999 5451 Adjustment Tool
999 5452 CAMSHAFT ADJUSTMENT TOOL See: Tools and Equipment/999 5452 Camshaft Adjustment Tool
Installing and adjusting the variable valve timing unit/timing gear pulley on the camshaft
Note! This procedure must be carried out with precision as any deviation could generate a fault symptom.
Installing the crankshaft adjustment tool
Remove the starter motor mounting screws. Pull out the starter motor and put it aside. Remove the plug of the gauge hole. Rotate the crankshaft slightly
clockwise. Install: 999 5451 ADJUSTMENT TOOL See: Tools and Equipment/999 5451 Adjustment Tool. Make sure that it bottoms against the engine
block.
Aligning the crankshaft
Turn the crankshaft counterclockwise to its stop against the crankshaft adjustment tool. Check that the marking on the crankshaft timing gear pulley
aligns with the marking on the oil pump.
Installing the variable valve timing unit on the camshaft