S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Carefully lower the fan cowling and align it with the retainers. Route the cable harness behind the retainer (3). Tighten the two retaining bolts. Press
down the hose from the expansion tank into the retainer on the fan cowling. Use cable ties (1) and (2) to secure the cable harness at the fan cowling. See
illustration. Fit the EVAP-valve. Plug in the electric cooling fan connectors.
Install:
-
the charge air hose/charge air pipe between the intercooler and the rubber connection on the turbocharger
-
the two charge air pipe bolts on the intake manifold
-
the intake manifold to the air filter housing
-
the intake manifold between the front and air filter housing.
Install:
-
dipstick guide tube
Turn the ignition key to position 2. Connect the battery cable to the negative battery terminal.
Ordering and downloading software
Note!
After ETM reload the ECM must be upgraded.
Order and download software for ETM reload and ECM gasoline upgrade.
Finishing work
Check that no diagnostic trouble codes were stored in the control module during repair work. Test drive the car and check the functionality of the engine.
C70 1999-2002 S70/V70 1999-2000 V70XC 1999-2000 5-CYL Turbo
Electronic Throttle Module (ETM) replacement 5-cyl Turbo C70 1999-2002 S70/V70 1999-2000 V70XC 1999-2000
Detach the battery cable from the negative battery terminal. Remove the dipstick guide tube.
Removing the electronic throttle module (ETM)