volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

SIPS (Side Impact Protection System) Module, Replacing|Page 22705 > < SIPS (Side Impact Protection System) Module, Replacing
Page 1
background image

Side Air Bag: Service and Repair
SIPS Airbag

SIPS Airbag

Replacing SIPS bag

Remove:

-

the seat from the car according to Lifting the front seats in and out

-

the lumber support adjustment knob according to Lumber support adjustment knob.

-

the side piece: Pull straight out.

-

the backrest adjustment knob according to Backrest adjustment knob.

Fold the backrest or position the backrest in the forward folded position.
Slacken off tension in lumbar support.
Remove the five half moon clips at the bottom edge of the backrest.
Remove seat upholstery as far as the first lateral channel: two half moon clips from each front-rear channel.
Remove seat upholstery three half moon clips in the first lateral channel.
Remove upholstery one half moon clip per side of the front-rear channel up to the upper lateral channel.

Release two elastic attachments in the inside/rear side of the backrest.
Pull up the backrest upholstery.
Bend out and expose the protective pad on the side where the SIPS is located.

Remove the two screws holding the SIPS bag to the inside of the backrest frame.
Pull the SIPS bag downwards and bend it slightly forward.
Remove the bag.

Cut cable tie.

Cut two tie straps.
Release the wiring.
Replace the SIPS bag.

Install:

In reverse order.

The SIPS screws should be torqued to 6 Nm (4.43 lb.ft).

SIPS (Side Impact Protection System) Module, Replacing|Page 22705 > < SIPS (Side Impact Protection System) Module, Replacing