S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Remove
-
the nut on the ball joint. Use a Torx wrench as a counterhold so that the boot is not damaged
-
wheel spindle.
For steel control arm, see: Ball joint, replacing See: Ball Joint/Service and Repair
Installing the wheel spindle
Install
-
the wheel spindle on the trailing arm
-
a new nut on the ball joint. Tighten. See: Tightening torque See: Steering/Specifications/Mechanical Specifications. Use a Torx wrench as a
counterhold to prevent damaging the boot.
For steel control arm, see: Ball joint, replacing See: Ball Joint/Service and Repair
Note! Make sure that the mating surfaces on the ball joint and control arm are clean.