S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Location Of Components (Solenoids)
Remove the screw from the solenoid. Remove the solenoid from the control system.
Lubricate the O-ring on the new solenoid. Use automatic transmission fluid.
Install the solenoid. Tighten the screw. Tighten to 7 Nm.
Finishing
Connect the connectors to the solenoids.
Installing the control system cover
Check that the mating surface for the cover is level.
Wipe the cleaned mating surfaces on the cover and transmission.
Note! Ensure that no dirt gets into the transmission.
Apply a bead of sealing compound, approximately 3 mm thick, to the cover.
Also apply sealing compound around the screw holes.