S60 2.4 L5-2.4L VIN 61 B5244S (2001)
Slacken off the support for the centre bearing from the propeller shaft and body.Turn the support upside down. Let the propeller shaft rest on the support.
Press the shaft nuts together. Move the shaft to one side and tie it up.
Removing the nuts for the bevel gear flange
Mark the position of the flange and nut in relation to the pinion shaft end
Remove the nut.
Use counterhold 999 5652 Counterh. See: Tools and Equipment/999 5652 Counterh. with adapter 999 7058 Adapter See: Tools and Equipment/999
7058 Adapter.
Removing the flange
Remove the flange. Use puller 999 5893 Puller See: Tools and Equipment/999 5893 Puller.
Check the seal face on the flange.
Replace the flange if it is damaged.
Removing the seal