S60 2.4T L5-2.4L Turbo VIN 58 B5244T3 (2001)
Center Mounted Brake Lamp: Service and Repair
Stop Lamp, Rear Windshield, Replacing
Stop lamp, rear windshield, replacing
Special tools:
951 2636 Terminal removal tool See: Tools and Equipment/951 2636 Terminal Removal Tool
Removing the stop lamp
Use clean gloves
To avoid customer complaints:
-
gloves which leave no prints must be used
-
visible surfaces, where the stop lamp can cover the rear windshield, must be kept unmarked and fault-free
-
visible surfaces on the stop lamp must be kept unmarked and fault-free.
Preparatory work
Remove:
-
three rear clips (1) in the headlining by twisting a quarter of a turn and pulling it out
-
the rear interior lighting (2). The mounting mechanism consists of metal springs
-
foam rubber (3) from the top of the headlining. Be careful. It must be reused.
Note! Note the position of the foam rubber.
-
connector (4) from the stop lamp
-
stop lamp wiring. Pull it out through the hole for the rear interior lighting.
Removing the stop lamp