S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Connect the existing loudspeaker connector (1) to the corresponding connector (2) from the new cable harness
-
The remaining connector (3) is connected to the loudspeaker
-
Use the foam tape from the kit to tape around the connectors. This is to prevent rattling
-
Repeat the operation on the other side.
-
Reinstall the loudspeakers on the right and left-hand sides. Install the guide pins for the loudspeakers in the corresponding holes in the D-post
-
Fold the loudspeakers upwards until the catches engage
-
Slide in the red catch (1).
Applies to the left-hand loudspeaker
-
Route the existing cable harness (1) out of the D-post panel. Press it into place in the clamp (2) for the loudspeaker
-
Reinstall the loudspeaker grilles on both loudspeakers
-
Clamp the loudspeaker cables at the existing cable harnesses at the D-post panel. Use four tie straps from the kit (two on each side).