S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Position the loudspeaker and the mountings (1) in the panel around the rectangular hole in the parcel shelf.
-
Adjust the loudspeaker towards the two predrilled holes in the panel.
-
Install the screws (2) from the kit. Tighten the loudspeaker.
-
Connect the loudspeaker to the pre-routed connector.
-
Carry out the above procedure on the opposite side.
-
Thread the seat belts through the holes in the parcel shelf.
-
Reinstall the parcel shelf panel.
-
Tighten the seat belt end mountings using the new screws from the kit. Tighten to 50 Nm (37 lbf ft.).
-
Reinstall the C-post panels
-
Reinstall the side bolsters.
-
Reinstall the seat cushion, if removed.
-
Reinstall the seat belts in the guides on the right and left hand side cushions.
-
Fold the backrests back into position.
Rear Door Bass Speakers
Rear door bass speakers
Preparations
Note! Carry out the operation on both sides.
-
Remove the clips (1) by pressing in the centre of the clips
-
Remove the blind cover plug (2) and the screw from under the blind cover plug
-
Disconnect the door panel by sliding the panel upwards and unhooking the top edge.