S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Note! On the XC90 Executive, T-wiring is already installed in the fuse holder. A cable with a black connector is taped to this. The tow bar
wiring's black connector is then connected to this cable.
-
Detach the trailer module (TRM) from the Velcro fastener on the floor along the rear edge of the left-hand rear wheel housing.
-
Plug in the tow bar wiring connectors:
-
green (GN) and grey (GR) connectors to the control module.
-
black (SB) connector to the fuse holder.
-
Reinstall the control module.
-
Secure the excess cable with a tie strap from the kit.
-
Insert fuses from the kit in the following positions in the fuse holder (REM):
-
20A in position 20 (mini fuse) if the charging function has been selected.
-
25A in position 29
-
25A in position 30
Reinstall:
-
the left-hand side panel using the screws and cover. Tighten the screws in the load securing eyelets. Tighten to 24 Nm (18 lbf ft).
-
the covers for the load securing eyelets.
-
D-post panel with connector.
-
the connector for the rear roof lighting (if applicable).
-
the rear headlining.
-
C-post panel.
-
protective cover and bracket for the battery.
-
side floor hatch and folding panel.
-
storage compartment and floor hatch.
Applies to connection of the function for automatic rear fog lamp deactivation
Note! The function requires car-specific software. Program the software according to the service information described in VIDA.
Checking the 7-pin connector: