S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Clean any underseal and dirt from the mating surfaces between the tow hitch cross member (1) and the car body
-
Install the screws (2, 3, 4) from the underneath with the washers (5) between. Finger tighten. Install a washer (6) on the left-hand side on the front
screw (4). This is to secure the rear mounting for the heat deflector plate using the screw (7). (See illustration 13B).
-
Install the heat deflector plate (1). Secure the heat deflector plate using the screw (7) and the washer (6)
-
Reinstall the rubber mounting (8) for the silencer.
Hint: Use normal soap to facilitate installation of the rubber mounting.
-
Tighten the screws (2). Tighten to 120 Nm (90 lbf.ft). Tighten the screws (3, 4). Tighten to 90 Nm (68 lbf.ft) on both sides
-
Underseal the car.
Applies to Sweden only:
-
Carry out this operation only after the state road worthiness inspection.