S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Install the cable harness for the tow hitch according to point 2 onwards in the Installation Instructions for the appropriate cable harness.
When installing a 7-pin or 13-pin cable harness for the tow hitch, a cut out (2) must be made in the lower edge of the bumper
-
Loosely install the bumper. Make markings for the cut-out for the cable harness
-
Cut out as illustrated so that there is room for the cable harness.
Finishing work and function test
-
If the mountings (1) have released from the rear edge of the wheel arch, reinstall the mountings. Press them completely back into their grooves and
screw in the screw a few turns
-
Reinstall the bumper by pressing it forwards. Ensure that the four screws protruding from the bumper align in the holes on the car
-
Before the bumper is completely installed, slide the top edge (2) into the grooves. Then slide the bumper fully in.
-
Tighten the screw (1) on both sides
-
Rivet (2) the bumper on the underneath on both sides
-
Reinstall the bumper nuts. Tighten the nuts. Tighten to 18 Nm (14 lbf.ft.).
Reinstall:
-
the antenna connector
-
the mudguards, if applicable