S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the protective film from the mounting tape for the spoiler
-
Reinstall the locating pins in the spoiler.
Illustration B
-
Insert the bushings in the bored holes in the panel
-
Grip both ends of the spoiler. Carefully insert the locating pins in the holes in the boot lid
-
Press the spoiler firmly against the boot lid
-
Take the M6 screws and the plastic washers from the kit
-
Open the boot lid. Remove the two locating pins
-
Apply locking fluid (P/N 1161053) to the screw threads
-
Tighten the screws to the spoiler. Tighten to 5 Nm (3.7 lbf. ft.).
Note! Do not exceed this torque.
Note! Leave the car indoors for 2 hours after carrying out the work. Do not wash the car for 48 hours.