S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Image A applies to cars with T stay, as illustrated
Image B applies to cars without T stay
-
Clean the area where the heater is to be installed. This ensures optimal heat conduction to the cylinder block. Also clean the internal threads.
-
Connect the cable supplied to the heater.
-
Install the heater on the engine block, as illustrated.
-
Install spacer washer (1) (t=10 mm (25/64")) between the mounting bracket (2) and mounting hole (3) in the engine block. The outer spacer
washer(4) (t=32 mm (1 1/4")) is inserted between the mounting bracket (2) and the T stay, if applicable.
-
Tighten the heater using the screws from the kit. Tighten to 16 Nm (12 lbf.ft.).
Applies to cars with stay for the turbocharger from model year 2005-
Note!
-
S60 CH 425000-
-
V70 CH 459000-
-
XC70 CH 173000-
-
S80 CH 390000-
-
XC90 CH 134000-
Illustration A