S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Remove:
-
the expansion valve, (2 screws)
-
the expansion valve block
-
the seal.
Installation
Evaporator
Install:
Note! Use new O-rings lubricated with compressor oil.
-
O rings on the evaporator pipe
-
the expansion valve.
-
Position the evaporator in the upper fan housing
-
Check that the seal sits in the correct groove at the expansion valve
-
Install the lower fan housing. Press so that the mounting lugs are in line with the upper half
-
Ensure that the mounting lugs line up
-
Check that the seal sits in the correct groove at the expansion valve
-
Press the upper fan housing into the lower
-
Check that the upper fan housing is secured to the lower
-
Install new retaining clips around the fan housing to ensure a good seal.
Install:
-
the central electrical unit seal
-
the central electrical unit. Screw it into place