S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the screws holding the expansion valve
-
Remove the expansion valve.
Installation
Note! Always use new O-rings lubricated with compressor oil.
-
Install the O-rings on the pipe from the evaporator
-
Install the expansion valve. Thread on the screws. Tighten the screws. Tighten to: 10 Nm
-
Install the O-rings on the pipes
-
Position the pipes and the holders towards the expansion valve. At the same time check that the pipes are on the correct holder at the member
-
Thread in the screw. Tighten the holder with the pipes on the expansion valve. Tighten to: 10 Nm
-
Install the heat shield. Secure the heat shield using the plastic nuts
-
Press the clamp together on the member
-
Install the engine stabilizer brace in the engine compartment.
-
Vacuum pump and test the system.
-
Fill the system with refrigerant. Check for leaks.
-
Connect the battery negative lead. See Battery, replacing See: Starting and Charging/Battery/Service and Repair/Removal and
Replacement/Battery, Replacing