S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Valve Clearance: Adjustments
Checking Valve Clearance
Checking Valve Clearance
Note: As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Preparation
Remove, (turbocharged engines)
-
the charge air pipe above the engine and holder at the rear of the engine
-
the cover over the intake camshaft
-
clamp the injectors cable harness.
Remove (common)
-
the upper timing cover
-
the cover over the ignition coils.
Remove (naturally aspirated engine)
-
the inlet hose between the Air Cleaner (ACL) and Throttle Body (TB)
-
the crankcase ventilation hose from the inlet hose. Place the inlet hose to one side
-
the Camshaft Position (CMP) sensor housing. Place to one side
-
the trigger wheel.
Remove (common)
-
the ignition coils without removing the connectors.
Note: Mark up before removal.
-
the two ground connections
-
the connector for the variable valve timing solenoid
-
the right front wheel
-
the plastic nuts holding the cover for the fender liner.
Set the engine to the test position