S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Front Steering Knuckle: Removal and Replacement
Wheel spindle, replacing
Special tools 999 5259, 999 5045, 951 2050
Removing the wheel spindle
Raise the car.
Remove
-
the wheel
-
the anti-roll bar link from the spring strut. Use a Torx wrench as a counterhold so that the boot is not damaged
-
the ABS sensor. Hang up the sensor using a piece of wire
-
The ABS sensor cable from the spring strut.
-
the brake caliper and limiter mounting screws the deflection limiter. Hang the caliper up using a piece of wire.
-
the drive shaft screw. Use a screwdriver as a counterhold on the brake disc
-
the locating pin holding the brake disc
-
the brake disc.
Slacken off the end of the drive shaft in the hub by knocking the drive shaft into the hub approximately 10 - 15 mm. Use a rubber or copper mallet.
-
Measure the position of the wheel spindle and spring strut.
-
Slacken off both the screws retaining the spring strut in the wheel spindle. Do not remove the screws yet.