S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Slide up the centering sleeves in the two rear mountings on the sub-frame.
Install the screws. Finger tighten.
Tighten:
-
the screws for the front mountings on the sub-frame. Install the screws through the brackets. See Tightening torque See:
Steering/Specifications/Mechanical Specifications.
-
the screws (M12) for the brackets.
Remove the screws for the rear mountings on the sub-frame. Remove the centering sleeves.
Install:
-
the screws for the rear mountings on the sub-frame. Tighten the screws. See Tightening torque See: Steering/Specifications/Mechanical
Specifications.
-
the fuel filter with the holder on the right bracket. Use an M8 screw.
Remove the lifting table.
Preparations for the installation of the final drive