S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Seals and Gaskets: Service and Repair
Connecting Sleeve
Connecting sleeve
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Removal and Installation
Remove and install connecting sleeve. Refer to: Sealing ring connecting socket drive shaft/differential, replacing. See: Drive Axles, Bearings and
Joints/Seals and Gaskets/Service and Repair/Sealing Ring Connecting Socket Drive Shaft/Differential, Replacing
Pinion Seal Bevel Gear, Replacing
Pinion seal bevel gear, replacing
Special tools:
999 7057 Counterhold See: Tools and Equipment/999 7057 Counterhold
999 7058 Adapter See: Tools and Equipment/999 7058 Adapter
999 5069 EXTRACTOR See: Tools and Equipment/999 5069 Extractor
999 5504 PRESS TOOL, DRIVE FLANGE See: Tools and Equipment/999 5504 Press Tool, Drive Flange
999 5652 Counterh. See: Tools and Equipment/999 5652 Counterh.
999 5653 Punch See: Tools and Equipment/999 5653 Punch
999 5682 Tensioner band See: Tools and Equipment/999 5682 Tensioner Band
999 5893 Puller See: Tools and Equipment/999 5893 Puller
Note! Check that the parking brake is not applied and that the gear selector is in position P.
Removal
Removing the three-way catalytic converter (TWC)
Remove the three-way catalytic converter (TWC). See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair
Note! The rear pipe must be supported at the front.Tensioner band 999 5682 Tensioner band See: Tools and Equipment/999 5682 Tensioner
Band can be used to support the pipe.
Marking the propeller shaft and flange
Mark the propeller shaft CV joint in relation to the bevel gear flange
Remove the screws from the propeller shaft.
Use counterhold 999 7057 Counterhold See: Tools and Equipment/999 7057 Counterhold.
Removing the propeller shaft