S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Remove the pinion seal.
Use puller 999 5069 EXTRACTOR See: Tools and Equipment/999 5069 Extractor.
Note! Check that no seal residue is left from the old seal.
Installation
Installing the seal
Install the seal.
Lubricate the sealing ring lip. Use wheel bearing grease, P/N 1161241-3. Install the seal on drift 999 5653 Punch See: Tools and Equipment/999 5653
Punch against the side of the tool marked 1155.
Press in the seal.
Use press tool 999 5504 PRESS TOOL, DRIVE FLANGE See: Tools and Equipment/999 5504 Press Tool, Drive Flange.
Installing the flange on the pinion
Install the flange as marked, see Removing the nuts for the bevel gear flange.
If necessary, use press tool 999 5504 PRESS TOOL, DRIVE FLANGE See: Tools and Equipment/999 5504 Press Tool, Drive Flange.
Installing a new nut in the carrier