S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Lifting the car
Note! Position the front lift arms so that they do not block the sub-frame's support plates.
Remove:
-
the front wheels
-
the splash guard under the engine
-
the outer front protection on both sides
-
both the screws for the front splash guard. Press in the catches at the front edge of the cover. Pull the cover backwards
Removing the screw for the right drive shaft
Remove the ABS sensor from the stub axle. Hang it up on the spring strut.
Remove the drive shaft screw. Counterhold using a screwdriver in the brake disc vents.
Removing the screws for the cable conduit and ground lead bracket on the sub-frame
Only applies to cars with parking heater:
Remove the three screws for the heater on the sub-frame.
Hang or tie up the heater on the left front wing.