S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Remove the ball bearings
Turn the inner joint ring and ball holder. Remove the ball bearings clockwise one by one.
Use the marking as the starting point when removing. See ball holder and inner ring.
Place the ball bearings in order so that they can be reinstalled in the same positions.
Remove the ball bearing holder and the inner ring from the shaft
Turn the inner ring 90° in relation to the ball holder.
Remove the inner ring.
Wash the constant velocity joint components thoroughly
Note! Replace the drive shaft assembly if any component has cracking or wear damage. Scratches and minor pitting of the ball tracks are
permitted.
Install the inner ring in the ball holder