S60 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2004)
Install the sealing ring for the adjustment nut.
Lubricate the sealing ring lip with wheel bearing grease, P/N 1161241-3.
Use drift 999 5655 Punch See: Tools and Equipment/999 5655 Punch. Tap in the seal until the drift reaches the nut.
Install a new O-ring on the nut. Lubricate the O-ring and threads with wheel bearing grease as above.
Installing the adjustment nut
Install the adjustment nut.
Use wrench 999 5371 NUTS-DIFF.BEARING) 1035 See: Tools and Equipment/999 5371 Nuts-Diff.Bearing) 1035 Turn the propeller shaft when the
nut is tightened to its previously measured position.
Checking the marking
Check that the marking corresponds exactly. Check the height. See Marking the position of the adjustment nut.
Install the split pin. Tighten the screw. Tighten to 50 Nm.
Checking the oil level in the bevel gear
Check the oil level in the bevel gear. See Bevel gear See: Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/Automatic
Transmission Components/Bevel Gear, Replacing Bevel gear, B5254T2, AW50/51 AWD See: Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement/Automatic Transmission Components/Bevel Gear, Replacing Bevel gear, B5254T2, M58 See: Automatic
Transmission/Transaxle/Service and Repair/Removal and Replacement/Automatic Transmission Components/Bevel Gear, Replacing.