S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
-
Route the cable harness from the tow bar connector through the hole in the floor.
-
Adjust the position of the rubber seal (1) so that there is not excessive cable slack under the car.
-
Install the rubber seal in the hole.
-
Route the cable harness as shown in the illustration. Pull up the sill trim panel on the left-hand side and place the cable harness in the space behind
the left-hand floor support. Make sure the cable harness is not pinched before reinstalling the sill trim panel.
-
Tighten the sill trim panel securely.
Illustration B
-
Secure the cable harness to the cable harness behind the battery with a tie strap (2) from the kit.
-
Connect the routed ground cable to the grounding point (3) behind the battery and tighten the grounding screw securely.
-
Detach the trailer module (TRM) from the front edge of the cover on the ventilation opening along the rear edge of the left-hand rear wheel
housing.
-
Plug in the tow bar wiring connectors:
-
green (GN) and grey (GR) connectors to the control module
-
black (SB) connector to the fuse holder
-
Reinstall the control module.
-
Secure the excess cable with a tie strap from the kit.