S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Preparations, rear suspension
-
Raise the car
-
Remove the rear wheels.
Illustration 7A only applies to cars with mudguards
-
Carefully drill out the rivets that hold the mudguard in place on both sides. Use a - 6 mm (1/4") diameter drill bit
-
Remove the mudguards.
Illustration 7B applies to all cars
-
Unscrew the screw (1) almost all the way on the left and right hand sides in the rear edge of the wheel arch
-
Press the screw using a screwdriver until the loose end pieces on the inside of the bumper cover are pressed backwards
-
Carefully drill out the rivets (2) underneath the bumper on both sides. Use a - 6 mm (1/4") diameter drill bit. Do not damage any of the plastic
components.
-
Pull the bumper backwards slightly. Bend out the sides (1) so that they detach from the mountings (2). Then pull the bumper backwards until it