S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Hint: Use soap to facilitate installation of the rubber mounting.
Illustration A
-
Tighten the screws (2). Tighten to 114 Nm (84 lbf.ft). Tighten the screws (4). Tighten to 81 Nm (60 lbf.ft), on both sides.
-
Underseal the car.
Applies to Sweden only:
-
Underseal after the state roadworthiness inspection.
-
Install the cable harness for the tow hitch according to step 2 onwards in the Installation Instructions for the appropriate cable harness.
When installing a 7-pin or 13-pin cable harness for the tow hitch, a cut-out (1) must be made in the lower edge of the bumper.
-
Loosely install the bumper. Make markings for the cut-out for the cable harness.
-
Cut out as illustrated so that there is room for the cable harness.
-
If the mountings (1) have released from the rear edge of the wheel arch, reinstall the mountings. Press the mountings completely back into their
grooves and screw in the screw a few turns
-
Applies to cars with parking assistance: Lift up the bumper in position. Pull the cable for the sensors through the hole for the bumper's guide,
and pull the cable in from the inside.
-
Reinstall the bumper by pressing it forwards. Ensure that the four screws protruding from the bumper align with the holes in the car.
-
Before the bumper is completely installed, slide the top edge (2) into the grooves. Then slide the bumper fully in.