S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
-
the 2 screws for the motor.
Carefully lower the headlining. Position several spacers between the sun roof unit and the headlining to avoid long term kinks.
Remove:
-
1 screw
-
the connector
-
the motor.
Hint: Use a ¼ ratchet handle with a Torx 25 socket for the last screw.
Installing the sun roof motor
Note! For tightening torques, see relevant specfications.
Connect the connector.
Screw the electric motor into place using the 3 M5 screws. Tighten.
Install:
-
the roof module. See Interior lighting and upper electronic module (UEM), replacing See: Lighting and Horns/Dome Lamp/Service and Repair
-
the panel / plastic molding around the headlining / sun roof. Start by pressing one corner into place, continue along a long side and then the shorter
sides and the corners. Finish with a long side.
Check that the sun roof is operating correctly. If this is not the case, see Sun roof module (SRM), calibrating See: Service and Repair/Procedures/Sun
Roof Module (SRM), Calibrating.