S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Thread the upholstery over the backrest cushion. Secure the half moon clips as the upholstery is pulled down. Use: 115 8962.
Install:
-
the Velcro seam on the reverse of the backrest cushion
-
the upholstery at the bottom edge
-
the lumbar support adjustment knob and its cover
-
the backrest adjustment knob (if applicable).
Install the head restraint. Press the head restraint down until the catches engage.
NOTE: Lift in the head restraint. Check that the head restraint cannot be moved upwards.
Install the front seat.
Upholstery Back Rest, Replacing
Upholstery back rest, replacing
Special tools:
115 8962 CRIMP PLIERS See: Tools and Equipment/115 8962 Crimp Pliers
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing backrest cushion upholstery
Remove the front seat. See: Front seat, replacing See: Service and Repair/Removal and Replacement/Front Seat/Front Seat, Driver's Seat/Front Seat,
Replacing.
Slacken off the tension in lumbar support.
Carefully detach the cover for the lumbar support adjustment knob. Pull the lumbar support adjustment knob straight out.
Press down the 2 catches on the bottom edge of the protective pad. Press through the upholstery.
Lift the head restraint upwards while the catches are pressed in.
Remove the head restraint.
If the front seat is manually operated, remove the backrest adjustment knob. Pull the knob straight out.
Fold the backrest cushion backwards if it can be folded. If the backrest cushion cannot be folded, position it in the forward angled position.