S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Install:
-
the brake pipe in the ABS hydraulic modulator. Tighten to 17 Nm
-
the brake pipe in its clips at the bracket. Adjust the pipe as necessary
-
the clip holder on the brake pipes by the side member
-
the bracket. Tighten to 12 Nm.
Note! The brake pipes must not be in contact with each other or the car body.
Check for leakage. Check that the ABS lines are correctly secured in their clips.
Install the wheel
See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Install the integrated relay / fusebox and the connector for the ABS unit
Hydraulic unit, replacing See: Hydraulic Control Assembly - Antilock Brakes/Service and Repair.
Install the air cleaner (ACL) housing
Brake pipe master cylinder / ABS unit, replacing See: Brake Pipe Master Cylinder / ABS Unit, Replacing.
Fill and bleed the brake system
See Brake system, bleeding (using bleeding unit) See: Brake Bleeding/Service and Repair/Brake System, Bleeding (Using Bleeding Unit).
Brake Pipe Hydraulic Unit / Junction / Front Wheel, Replacing
Brake pipe hydraulic unit / junction / front wheel, replacing
-
For S80 and S60, see Replacing the brake pipe between the hydraulic unit, front wheel and junction , B5254T2 See: Replacing the Brake Pipe
Between the Hydraulic Unit, Front Wheel and Junction
-
For V70 and V70 XC/XC70, see Brake pipe from hydraulic unit / front wheel / junction, replacing See: Brake Pipe From Hydraulic Unit / Front
Wheel / Junction, Replacing
-
For XC90, seeand.