S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Installation
Fuel gauge sensor
-
Position level sensor correctly
-
Install a new rubber seal
-
Connect the 2 connectors to the level sensor
-
Press tube system onto level sensor
-
Carefully position level sensor down with tube system and wires
-
Install level sensor attaching ring but do not tighten it
-
Press level sensor into position. Note position marks on cover and tank
-
Tighten lock ring, first by hand and then using special tool 999 5720 Wrench See: Tools and Equipment/999 5720 Wrench
-
Install wire in rubber seal slots
-
Connect the connector
-
Install level sensor cover
-
The rest of the section is done in reverse order.
Additional information
To replace fuel gauge sensor on right side, see Right side fuel pump with level sensor See: Right Side Fuel Pump With Level Sensor.
Level Sensor, Fuel Tank Left, Replacing
Level sensor fuel tank left, replacing
Special tools:
999 5720 Wrench See: Tools and Equipment/999 5720 Wrench
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Disconnecting the battery lead
Disconnect the battery negative lead. See: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Warning! Explosion risk.Use a fresh air mask.
Draining fuel tank
Note! Before draining the fuel, see: Safety regulations for handling fuel See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Safety Regulations for Handling Fuel.
Insert the heavy duty hose 1.3 meters into the fuel filler pipe, measured from the edge of the opening of the filler pipe.
Pump until air comes out.
V70: Fold up both sides of the rear seat. Remove the rear seat.
S80, S60: Remove the seat cushion for the rear seat.
Removal
Removing the insulation panel