S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Center Mounted Brake Lamp: Service and Repair
Stop Lamp Rear Spoiler, Replacing
Stop lamp rear spoiler, replacing
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Note! Up to model year 2003, the cable (1) is routed to the left-hand side of the rear door. After this, it is routed to the right-hand side.
Removing the stop lamp
Remove:
-
the tailgate panel. See Panel, tailgate, replacing
-
the blind cover plugs (2) for the screws
-
the screws (3).
Remove the stop lamp.
Disconnect the connector.
Cut off the cable at the connector. Tie a cord or similar to the end of the cable. Pull the cable through the spoiler.
Hint: If necessary, enlarge the hole in the spoiler to accommodate the cable. Use an 8 mm drill bit. Use a drill stop.
Installation
Tie the new cable to the cord, and pull the new cable into position.
Align the stop lamp
Install:
-
the screws (3). Tighten
-
the blind cover plugs (2)
-
the pins in the connector. Connect the connector. Secure the cable in the clips
-
the tailgate panel. See Panel, tailgate, replacing .
Test the function.