S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Note! Make a note of the position number of the connector. These are located on the ends of the connector and in the bottom of the fuse holder.
-
Connect the green (GN) cable to position 19 in the connector. Connect the white (W) cable to position 30.
-
Reinstall the connector in the holder
-
Reinstall the connector in the fuse holder.
-
Refit the Rear Electronic Module (REM).
-
Fit fuse 15A from the kit in position 3 on the fuse holder.
-
Tighten the bracket of the accessory electronic module in the rear right hole for the floor support parallel to the side member as illustrated. On
newer cars, there is a foam rubber block on the right-hand side member. This is to be kept in place and is compressed when the bracket is fitted in
place.
-
Drill a -4 mm (5/32") hole in the side member, through the front hole in the bracket.
-
Remove the screw and the bracket
-
Remove any swarf.
-
Treat the edges of the holes using a rust-proofing agent.