S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Note! The illustration shows the right-hand side. The corresponding work is also carried out on the left-hand side.
-
Measure and mark out for the holes in the foam as illustrated.
Illustration B shows measuring for the sensor connector sockets
-
Measure and mark out for the extra holes -30 mm to the right of the hole markings.
-
Drill through the foam using a -40 mm diameter hole saw at the four markings.
Drilling holes in the rear section
Note! The illustration shows the right-hand side. The corresponding work is also carried out on the left-hand side.
-
Measure out for the holes for the outer sensor holders.
-
Drill out the holes using a -40 mm diameter hole saw.
Note! No holes are required for the inner sensors.
Installing the sensor holders