S60 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Power Steering Line/Hose: Service and Repair
Hydraulic Pipes/Hoses Steering Gear, Replacing
PRESSURE PIPE/HOSE, STEERING GEAR, REPLACEMENT
NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Preparatory work
Remove the battery lead. See Battery, disconnecting.
Hint: Place paper or a rag under the supply pipe to absorb any oil spillage.
Install a hose clip on the feed hose for the power steering pump.
Remove the pressure line from the power steering pump.
Removing the sub-frame
Remove the sub-frame.
Removing the delivery lines
Position a container under the steering gear.
Remove:
-
the supply pipe from the steering gear. Drain the oil
-
release the supply pipe /hose from the clip
-
the supply pipe.
NOTE: Note the routing of the supply pipe / hose.
Installation
NOTE: For tightening torques, see: Specifications.
Installing the supply pipe / hose
Install:
-
the supply pipe and return pipe to the steering gear. Tighten
-
the supply pipe / hose in the clip for the steering gear.
NOTE: Use a new O-ring.
Installing the sub-frame
Install the sub-frame.
Installing delivery lines
Install the supply pipe on the power steering pump.
NOTE: Use a new O-ring.
Remove the hose pliers from the supply line.
Finishing